The ventilation space can be:
• directly above the appliance
• behind and above the top cupboard.
In this case, the space behind the top
cupboard must be at least 50 mm
deep.
8.3 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.
8.4 Removing the transport
support
Your appliance is equipped with
transport support to secure the door
during transportation.
1. Open the door.
2. Remove the transport support from
the door sides.
3. Remove the transport support from
the lower hinge (some models).
CAUTION!
Some models are fitted with
a silencing pad under the
cabinet. Do not remove this
pad.
8.5 Rear spacers
Install the two spacers and the locking
pins provided within the accessory bag
as shown in the figure.
8.6 Levelling
When placing the appliance ensure that
it stands level. If necessary adjust the
feet using the adjustment spanner
supplied. Door alignment is dependent
on proper levelling.
ENGLISH 15
To Next Page
Loading...
