Electrolux SteamBake 600 - How to remove: Shelf supports; How to use: Pyrolytic Cleaning

Step 1 Step 2 Step 3
Pour: 250 ml of white vinegar into
the cavity embossment. Use maxi‐
mum 6% vinegar without any addi‐
tives.
Let the vinegar dissolve the lime‐
stone residue at the ambient tem‐
perature for 30 minutes.
Clean the cavity with warm water
and a soft cloth.
For the function: SteamBake clean the oven for every 5 - 10 cooking cycles.
12.3 How to remove: Shelf supports
Remove the shelf supports to clean the oven.
Step 1 Turn off the oven and wait until it is
cold.
Step 2 Pull the front of the shelf support
away from the side wall.
Step 3 Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Step 4 Install the shelf supports in the oppo‐
site sequence.
The retaining pins on the telescopic
runners must point to the front.
12.4 How to use: Pyrolytic Cleaning
Clean the oven with Pyrolytic Cleaning.
WARNING!
There is a risk of burns.
CAUTION!
If there are other appliances installed in
the same cabinet, do not use them at the
same time as this function. It can cause
damage to the oven.
Before the Pyrolytic Cleaning:
Turn off the oven and wait until
it is cold.
Remove all accessories. Clean the oven floor and the inner door
glass with warm water, a soft cloth and
a mild detergent.
Pyrolytic Cleaning
Step 1
Enter menu: Cleaning .
Option Duration
148 ENGLISH