11.2 Troubleshooting
Problem Possible cause Remedy
The tumble dry‐
er does not op‐
erate.
The tumble dryer is not connec‐
ted to the mains supply.
Connect it to the mains socket.
Check the fuse in the fuse box
(domestic installation).
The door is open. Close the door.
The On/Off (Ein/Aus) button
was not pushed.
Push the On/Off (Ein/Aus)
button.
The Start/Pause button was
not touched.
Touch the Start/Pause but‐
ton.
The appliance is in standby
mode.
Push the On/Off (Ein/Aus)
button.
Unsatisfactory
drying result.
Incorrect programme selection.
Select a suitable programme.
1)
The filter is clogged.
Clean the filter.
2)
Dryness (Trockengrad) op‐
tion was set to
iron dry (Bü‐
geltrocken)
.
3)
Change Dryness (Trocken‐
grad) option to a higher level.
The load was too large. Do not exceed the maximum
load size.
The airflow slots are clogged. Clean the airflow slots at the bot‐
tom of the appliance.
There is some dirt on the humidi‐
ty sensor in the drum.
Clean the front surface of the
drum.
The dryness level was not set to
the desired level.
Adjust the dryness level.
4)
The condenser is clogged.
Clean the condenser.
2)
The loading
door does not
close
The filter is not locked into posi‐
tion.
Put the filter in the correct posi‐
tion.
Laundry is trapped between the
door and the seal.
Remove trapped items and close
the door.
It is not possi‐
ble to change
the programme
or option.
After a cycle starts it is not possi‐
ble to change the programme or
option.
Turn the tumble dryer off and on.
Change the programme or op‐
tion as required.
It is not possi‐
ble to select an
option. An
acoustic signal
is emitted.
The option you tried to select is
not available for the selected
programme.
Turn the tumble dryer off and on.
Change the programme or op‐
tion as required.
ENGLISH 23
To Next Page
Loading...
