WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
error code and the Start/Pause button may flash continuously:
Error code Possible cause Remedy
E50
Appliance motor overloaded.
Too much laundry or entrap in
the drum.
The programme was not comple‐
ted. Remove the laundry from
the drum, set the programme
and restart the cycle.
E90 or E91
Internal fail. No communication
between electronic elements of
the appliance.
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance
off and on again.
If the error code appears again,
contact the Authorised Service
Centre.
EH0
The mains supply is unstable. When the appliance is showing
EH0, please wait until main sup‐
ply is stable than press start. If
the appliance pause the cycle
without any indication then press
the cycle start. If the warning will
occur check the power cord /
socket integrity or main supply.
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
11.2 Troubleshooting
Problem Possible cause Remedy
The tumble dry‐
er does not op‐
erate.
The tumble dryer is not connec‐
ted to the mains supply.
Connect it to the mains socket.
Check the fuse in the fuse box
(domestic installation).
The door is open. Close the door.
The On/Off (Ein/Aus) button was
not pushed.
Push the On/Off (Ein/Aus) but‐
ton.
The Start/Pause button was not
touched.
Touch the Start/Pause button.
The appliance is in standby
mode.
Push the On/Off (Ein/Aus) but‐
ton.
www.electrolux.com22
To Next Page
Loading...
