Problem Possible cause Remedy
Unsatisfactory
drying result.
Incorrect program selection.
Select a suitable program.
1)
The filter is clogged.
Clean the filter.
2)
Dryness Level (Trockengrad) op‐
tion was set to
Iron Dry
.
3)
Change Dryness Level (Trocken‐
grad) option to a higher level.
The load was too large. Do not exceed the maximum
load size.
The airflow slots are clogged. Clean the airflow slots at the bot‐
tom of the appliance.
There is some dirt on the humidi‐
ty sensor in the drum.
Clean the front surface of the
drum.
The dryness level was not set to
the desired level.
Adjust the dryness level.
4)
The condenser is clogged.
Clean the condenser.
2)
The loading
door does not
close
The filter is not locked into posi‐
tion.
Put the filter in the correct posi‐
tion.
Laundry is trapped between the
door and the seal.
Remove trapped items and close
the door.
It is not possi‐
ble to change
the program or
option.
After a cycle starts it is not possi‐
ble to change the program or op‐
tion.
Turn the tumble dryer off and on.
Change the program or option
as required.
It is not possi‐
ble to select an
option. An
acoustic signal
is emitted.
The option you tried to select is
not available for the selected
program.
Turn the tumble dryer off and on.
Change the program or option
as required.
Unexpected
duration time
appears on the
display.
The drying duration is calculated
according to load size and
dampness.
This is automated - the appli‐
ance is working correctly.
A program is
inactive.
The water container is full. Drain the water container, push
the Start/Pause button.
2)
The drying cy‐
cle is too short.
The load size is small. Select a time program. The time
value must be related to the
load. To dry one item or a small
amount of laundry we recom‐
mend short drying times.
The laundry is too dry. Select an appropriate time pro‐
gram or a higher dryness level
(e.g.
extra dry
)
ENGLISH 23
To Next Page
Loading...
