1010
Cleaning the motorized nozzle
Always disconnect the nozzle before cleaning it !
Disconnect the nozzle from the tube. Use the hose han-
dle to clean the nozzle.
If the wheels are stuck, clean them by removing the
wheel cap (only at the AeroPro nozzle) with a small
screwdriver.
-
verse order.
Open brush roll cover by pushing the latches. This will
free the front wheels for cleaning.
Pull out the brush roll and remove entangled threads by
snipping them away with scissors. Use the hose handle
If the wheels are stuck, remove them carefully by using
a small screwdriver.
Cleaning the nozzle
To Next Page
Loading...
