Electrolux vacuum cleaner - Vacuuming with Accessories

3
Vacuuming with accessories
For your safety, turn power switch to ‘off’ before
attaching accessories. Press switch to ‘hard floor’
setting when using accessories.
To use accessories: With Quick Release handle in upright
position, rotate handle release latch forward, then lift
handle and pull away from vacuum cleaner body (Fig. 1).
n
Extend or shorten the telescopic wand by pressing
release button ➁ (Fig. 2).
n
Use crevice tool or turbo nozzle with or without wand.
Press button ➀ to pull wand off handle (Fig. 2).
Dusting brush
Use for baseboards, furniture, vents and blinds (Fig. 4).
n
To use, press dusting brush button ➂ and slide brush
to end of wand until it clicks (Fig. 3).
n
After using, slide brush back until it clicks.
Turbo nozzle
Use for stairs and upholstered furniture (Fig. 6).
n
To use, push nozzle onto handle or wand until snug.
n
Store turbo nozzle on front of vacuum.
n
Position vacuum cleaner on floor at bottom of stairs,
pushed against bottom step (Fig. 7).
n
For your safety, do not place vacuum at top of stairs
or on steps.
Electrolux Customer Service 1-800-896-9756
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5 Fig 6
Fig 7
Fig 8A
➀
➁
➂
Fig 8B
Crevice tool
Use for grooves, narrow openings, tight spaces (Fig. 5).
n
To use, push tool onto handle or wand until snug.
n
Store crevice tool on back of vacuum.
After using accessories
n
Press button ➁ to shorten wand. Press button ➂ and
slide dusting brush back into storage position (Fig. 2).
n
If wand is off, push back onto handle until it clicks.
n
Place wand into opening on back of vacuum (Fig. 8A).
n
Align ribs on wand into grooves at top of vacuum
(Fig 8B). Push down handle until it locks into position.
!
!
!
!
ENGLISH
79976A OG eng_English 12/10/10 2:10 PM Page 5