The symbol of the set level stays
on (e.g. Cupboard dry).
The other level symbols go off.
The display updates regularly the drying
cycle time (every minute).
You cannot set all levels for
all kind of laundry (refer to
"Programmes for automatic
drying" table) .
10.3 Timed drying
1. Press button Trockenzeit - Minuterie
repeatedly to set the time value (see
the «Drying Programme» table).
The drying symbol comes on.
The anti-crease symbol comes on.
The drying time symbol comes on.
Set time value.
Each time you press this button the time
value increases by 5 minutes. The display
shows the set time value.
After some seconds the set time value on
the display changes: the appliance
calculates also the duration of the anti-
crease and the cooling phases.
Final time value.
2. Press Start/Pause - Départ/Pause to
start the programme. The text bar tells
that the appliance is drying. The
display shows the new time value
every minute.
The drying symbol starts to flash.
The door locked symbol comes
on.
If you set the time value of
only 10 minutes, the
appliance performs only a
cooling phase.
10.4 At the end of the drying
programme
1. The appliance stops automatically.
2. The acoustic signals operate (if they
are active).
3. In the display comes on.
4. The indicator of button Start/Pause -
Départ/Pause goes off.
5. The last minutes of the drying cycle
the appliance performs the anti-crease
phase.
The anti-crease symbol
flashes.
The door is still locked (the symbol
is on).
6. Press button Ein/Aus - Marche/Arrêt
for some seconds to deactivate the
appliance.
After some minutes from
the end of the
programme, the energy
saving function
automatically deactivates
the appliance.
7. When the door locked light goes
off you can open the door.
8. Remove the laundry from the
appliance. Make sure that the drum is
empty.
9. Keep the door ajar, to prevent mildew
and odours.
10. Close the water tap.
11. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
www.electrolux.com24
To Next Page
Loading...
