Need help?Do you have a question about the Electron HS 12/24-30 and is the answer not in the manual?
General| Output Voltage | 12/24V DC |
|---|---|
| Output Current | 30A |
| Charging Method | IUoU |
| Weight | 2.5 kg |
| Battery Type | Lead-acid, Gel, AGM |
| Protection | Short circuit, Overvoltage, Overtemperature |
| Cooling | Fan |
Ensures mains and charging cables are in perfect condition. Contact workshop if damaged.
Read instructions, operate according to them, and ensure good ventilation.
Caution regarding explosive gases generated during charging. Avoid fire and sparks.
Wear protective goggles. Wash skin/clothing immediately if acid splashes occur.
In case of gas smell, ventilate immediately, do not switch off or remove clips.
Suitable for 12/24V wet, maintenance-free gel, fleece, and AGM batteries.
The required voltage is selected using the 'charging voltage switch' (1).
LEDs indicate charging status. Yellow LED (0%) flashes if no battery or contact.
Use switch (5) to select between 2.4 V/cell and 2.35 V/cell for battery types.
Connect clips, select voltage, observe charging indicators, switch off when charged.
Charger detects and carefully charges exhausted batteries, adjusting current.
Maintains onboard voltage during battery changes. Requires minimum load current.
Ensures optimum charging and floating for unlimited periods. Handles discharge.
Indicates overheating or incorrect polarity. Check air outlets/intakes or polarity.
Signifies a system fault in the charger. Switch off and contact dealer.
Check battery voltage and set switch (1) accordingly. Fault indicator extinguishes after correction.
Check battery for defective cells or incorrect charging voltage selection.
Details mains voltage, frequency, nominal voltage, constant voltage, and charging current.
Covers protection type, housing dimensions, weight, and cable lengths.
To Next Page