Electus Distrubution MS-6115 - Setting Cost Price Per kWh; Setting Price 1; Setting Price 2

2
2. Press SET button once time, The “WEEK DAY“will flash at same time, the clock change to SET mode. you can set the current
clock now.
3. Press UP button to set the “WEEK DAY“.
4. Press SET button once time again and release, The “HOUR“will flash.the “WEEK DAY“will stop flashing and keep display.
5. Press UP button to set the “HOUR“.
6. Press SET button once time again and release, The “MINUTE“ will flash. the “HOUR“will stop flashing and keep display.
7. Press UP button to set the “MINUTE“.
8. Press SET button once time again and release, the time come back to CLOCK display mode.
9. Press UP button during the CLOCK display state, change 12-24 hour mode.
To reset incorrect time, repeat above steps.
After finish setting, Plug the meter into a regular 240 Volts power outlet, Plug in an appliance that you want to use and turn the
mains power on. Now the meter begins to measure the consumption of the appliance and detect the equipment that uses too much
electricity at once.
SETTING PRICE OF COST/kWh
Press and hold FUNC button for 5 seconds during display state of voltage or current or power.
1. Setting price 1:
a. Press SET button once and release, SET display, the first digital COST/kWh flash, press UP button to set it.
b. Press SET button once again and release, the second digital COST/kWh flash, press UP button to set it.
c. Press SET button once again and release, the third COST/kWh flash, press UP button to set it.
d. Press SET button once again and release, the fourth COST/kWh flash, press UP button to set it.
e. Press SET button once again and release, the radix point COST/kWh flash, press UP button to set it.
f. Press SET button once again and release, the weekday flash, press UP button to set it.
g. Press SET button once again and release, the hour of ON TIME flash, press UP button to set it.
h. Press SET button once again and release, the minute of ON TIME flash, press UP button to set it.
2. Setting price 2:
Press FUNC button once and release after finish Setting price 1. Setting price 2, repeat above steps.
STAND BY MODE
Display of LCD will disappear without any operation after AC power off for 10 seconds. Press any key come back
To display.
SPECIFICATIONS
Power supply 240V AC 50Hz
Max. load 10A, 2400W
Measure voltage range 200-276V AC
Measure voltage accuracy +/-1%
Measure current range 0.01-10A
Measure current accuracy +/-1% or +/-0.01 A
Measure power range 0.2W-2760W
Measure power accuracy +/-1% or +/-0.2W
Accumulative electric quantity range 0 -9999.9kWh
Measure frequency range 45-65Hz
Clock accuracy +/- 1 minute per month
Power cost <0.5W
Operating temperature -10
o
C to +40
o
C
Battery 3x1.5V LR44/AG13
Battery life about 3 months without AC power
Distributed by
Electus Distrubution Pty Ltd.
320 Victoria Road,Rydalmere,NSW 2116 Australia.
Phone:1300 738 555
Facsimile:1300 738 500
www.electusdistribution.com.au
Made in China