TROUBLE SHOOTING
The following chart lists problem symptoms, possible causes and corrective action, if your machine does not
operate properly. If these do not identify and correct the problem, contact your service agent : info@eco-repa.com
Warning !
Before any intervention on the appliance, disconnect the mains plug.
Machine fails to
operate
Power turned off Turn power on.
Mains socket faulty Use another socket
Extension cable damaged Inspect cable, replace if damaged
Mower in long grass Increase height of cut and tilt mower
Machine functions
intermittently
Extension cable damaged Inspect cable, replace if damaged
Machine leaves ragged
finish
Or motor labours
Height of cut too low
Increase height of cut
(see “Height of Cut Adjustment”)
Cutting blade blunt
Replace blade
(see “Blade Maintenance”)
Underside of machine badly clogged
Clean machine
(see “After Mowing/Storage”)
Blade fitted upside down
Refit blade correctly
(see “Blade Maintenance”)
Cutting blade not
rotating
while machine switched
on
Cutting blade obstructed Clear obstruction
Blade nut/bolt loose Tighten blade nut/bolt
Excessive
vibration/noise
Blade nut/bolt loose. Tighten blade nut/bolt
Cutting blade damaged Replace blade
You can request the instruction manual in PDF format by email: info@eco-repa.com
Made in China 2020