First - and above all else - is the health, safety, and well-being of your baby. We believe that you
will benefit from the eClip - but nothing can replace responsible parenting.
First, download and install
the eClip app that is
suitable for your device.
elepho.com/apps
The eClip includes a battery that should give you 500 hours of
continuous use. It is shipped at full strength, and is protected against
discharge by a plastic tab.
eClip (battery included)
eClip Accessory Strap
eClip Quick Setup Guide.
A.
B.
C.
So, first, let’s pull the plastic tab out.
1. Remove the eClip from the box and turn it over.
2. Take a coin and rotate the battery cover counter-clockwise until it
comes off.
3. Lift up the battery, take the plastic tab out, and dispose of it.
4. Put the battery back in place, with the flat side, marked with a plus
sign (+), facing up.
5. Replace the battery cover, turning it clockwise with a coin, until the
coin is in line with the two H-clips.
Once you close the battery cover the eClip‘s red LED flashes quickly
three times to indicate that it is on. It will then continue to flash about
once every second.
Reminder! After every journey, always
check that you have removed your child
from the car.
The eClip Full User Guide can be downloaded or viewed here:
elepho.com/eclip/full-user-guide.pdf
Note: Make sure that you give the eClip app permission to use
your smartphone’s Bluetooth and GPS. Without these services
the eClip cannot monitor your baby.
Note: The eClip app should be compatible with the latest
Android and iOS versions. For a full list of compatible versions
see either the Full User Guide or visit elepho.com/apps
Note: The battery cover is tight to prevent young children from
opening it.
Note: If the eClip is disconnected from the eClip app for more
than three minutes it will automatically turn off.
1. First Things First
eClip - Quick Setup Guide
3. Set it Up
Preparing the eClip Battery
2. In the Box
CR2032
3V
A
B
C
www.elepho.comeClip - Quick Setup Guide
As you can see from the eClip packaging, you have your choice of four
convenient options to secure the eClip.
Baby car
seat strap
Standard adult
seat belt
Diaper bag
strap
Included strap
accessory
Warning: Always check manufacturers’ recommendations
before attaching the eClip to the strap of your baby’s car seat
or your vehicle’s adult seat belt.
1. Slide one edge of the strap under one side of the H-clip on the
back of the eClip.
2. Push the other edge of the strap under the second side of the clip.
It should fit snugly.
Once you’ve chosen a location for the eClip set it in place, as
follows:
Warning: Always make sure that the eClip stays out of your
baby’s mouth and that no liquids are spilled on or into the
eClip.
21
4. Installing the eClip in Your Car
To Next Page
Need help?
General
