Elettronica Santerno SINUS K Series User Manual

• 15R0095B2 •
SINUS K
FULL DIGITAL INVERTER
PROGRAMMING
MANUAL
R02 Updated 20/04/05
Software Version
IFD V2.03x / VTC V2.03x
Supersedes R01 03/12/04
Elettronica Santerno S.p.A.
Via G. Di Vittorio, 3 – 40020 Casalfiumanese (BO) Italy
Tel. +39 0542 668611 – Fax +39 0542 668622
www.elettronicasanterno.it
sales@elettronicasanterno.it
• This manual is integrant and essential to the product. Carefully read the instructions contained herein as they
provide important hints for use and maintenance safety.
• This device is to be used only for the purposes it has been designed to. Other uses should be considered improper
and dangerous. The manufacturer is not responsible for possible damages caused by improper, erroneous and
irrational uses.
• Elettronica Santerno is responsible for the device in its original setting.
•
Any changes to the structure or operating cycle of the device must be performed or authorized by the Engineering
Department of Elettronica Santerno.
• Elettronica Santerno assumes no responsibility for the consequences resulting by the use of non–original spare–
parts.
• Elettronica Santerno reserves the right to make any technical changes to this manual and to the device without prior
notice. If printing errors or similar are detected, the corrections will be included in the new releases of the manual.
• Elettronica Santerno is responsible for the information contained in the original version of the Italian manual.
• The information contained herein is the property of Elettronica Santerno and cannot be reproduced. Elettronica
Santerno enforces its rights on the drawings and catalogues according to the law.
English

Elettronica Santerno SINUS K Series Specifications

General

Brand	Elettronica Santerno
Model	SINUS K Series
Category	Inverter
Language	English

Summary

GENERAL FEATURES

INPUT SIGNALS AND OUTPUT SIGNALS

DIGITAL INPUTS

Describes the functionality and connection of digital inputs.

MAIN REFERENCE

PROGRAMMABLE FUNCTIONS

SENSORLESS VECTOR CONTROL (VTC SW only)

Details the advanced control technique for asynchronous motors.

POWER DOWN

Explains how to maintain inverter operation during mains failure using kinetic energy.

DC BRAKING

Describes DC injection methods to stop the connected motor.

MOTOR THERMAL PROTECTION

Explains the function that protects the motor against possible overloads.

PID REGULATOR

Explains the PID regulator for regulating physical variables like pressure or speed.

PROGRAMMING PARAMETERS

COMMON MENUS TO IFD SW AND VTC SW

LIST OF IFD SW PARAMETERS

LIST OF VTC SW PARAMETERS

MEASURE/PARAMETER MENU

Details the Measure/Parameter menu, including Mxx and Pxx parameters.

CONFIGURATION MENU

Lists the Cxx parameters that can be altered when the inverter is not running.

DIAGNOSTICS

ALARM MESSAGES

Lists and explains various alarm codes and their troubleshooting solutions.

SERIAL COMMUNICATION

MODBUS–RTU PROTOCOL

PARAMETERS SENT VIA SERIAL LINK (IFD SW)

CONFIGURATION PARAMETERS (Cxx) (Read/Write with inverter disabled, Read Only with inverter in RUN mode)

PARAMETERS SENT VIA SERIAL LINK (VTC SW)

MEASURE PARAMETERS (Mxx) (Read Only)

PROGRAMMING PARAMETERS (Pxx) (Read/Write)

MOTOR THERMAL PROTECTION MENU C6X

D.C. BRAKING MENU C7X

SELECTING THE APPLICATION SW (IFD SW OR VTC SW)

FLASH PROGRAMMING

DSP PROGRAMMING

SELECTING THE APPLICATION SOFTWARE