Page 8Rev. 071520
1-888-651-3431
7. The following steps are from carrier to the trolley. Loosen the bent pin, clamp the hand wheel,
rotate bending pin to 90 degrees as loosen state, pull the square of the xed the square pin (2 Pcs),
turn up the right carrier frame, the U-tube handle stretched out automatically from the left carrier
frame, and adjust the U-tube handle after spinning in place, insert and x the square pin (2 Pcs), pull
out the long bent pin, then move out the carrier frame until see the square tube in the middle of the
frame. Connect two solid rollers (2 Pcs) with long bar bent pins, x with M3.8 Split pin on the other
end, and move the frame again until the wheel hits the ground. See FIG 7.
8. Below are the carrier and trolley setups. See FIG 8.
To Previous Page
Loading...