Door & Wall Rack Assembly Instructions
(continued)
©2023 The Container Store Inc. All rights reserved. WF227200 06/23
For assembly video, visit containerstore.com/elfa/installation.htm
Complete Solutions:
Installed Using Overdoor Hooks
Installed into a Door
Installed into a Wall
Installing into a Hollow Door or Drywall
Adding Assessories
Installing into a Solid Door or Wall Studs
• Align the tabs on the back of Accessory
with the slots on the Standard.
• Pull down to hook in place.
• Repeat the process with all Accessories.
• Drill holes using a 1/4"/7mm drill bit and
insert Hollow Door Anchors or Drywall
Anchors.
• Insert screws into anchors and tighten.
• Drill a pilot hole with a 1/10"/2.5mm drill
bit at each marked spot.
• Screw Standard to the door or wall with
wood screws.
• Mark screw placements.• Position Standard on door or wall. Using a
Level, adjust the Standard until it is square
to the floor.
• Position Standard on door or wall. Using a
Level, adjust the Standard until it is square
to the floor.
• Mark screw placements.
To Previous Page
Loading...