Elfa CLASSIC User Manual

Door & Wall Rack Assembly Instructions
Things Youʼll Need -
For Overdoor Hook Method: Level.
For Into Door or Wall Method: Level, Pencil,
Drill or Screwdriver, and Hardware.
Component Options:
Hardware Options:
Residential or
Commercial
Overdoor
Hooks
with
Hardware
77-3/4" or
94-5/16"
Mounted
Standard
Small Mesh
Basket
Medium Mesh
Basket
Large Mesh
Basket
Shoe Rack
Utility Pegboard
HELPFUL TIP
• If not using the overdoor hooks, please ask for the best installation hardware
for your specific needs.
Installing with Overdoor Hooks
• Place the short Residential or Commercial
Overdoor Hook (that has a bolt) over the
top of the door.
• Fit the second set of slots on the Standard
over the hook.
• Using a Level, adjust the Standard until it is
square to the floor.
• Attach the long Residential or Commercial
Overdoor Hook to the Standard under the
bottom of the door.
• Pull down to lock it in position. The bottom
hook should not be tight against the door.
• Use the included Allen Wrench to tighten
the top bolt.
Package of Ten
Wood Screws
Package of Five Hollow
Door Anchors and Screws
(Baskets are available in mesh and wire.
Ask a Specialist for assistance.)
Package of Five
Drywall Anchors
Gift Wrap Rack
Utility Pegboard Boxes
Utility
Pegboard
Hooks
(Multiple sizes to choose from)
(Multiple styles
to choose from)

Elfa CLASSIC Specifications

General

Category	Indoor Furnishing
Mounting	Wall-mounted
Material	Steel
Adjustability	Yes
Color	White
Type	Wall-mounted Shelving System

Summary

Installing with Overdoor Hooks

Positioning and Securing the Standard

Place the short hook over the door, fit the standard into slots, attach the long hook, and pull down to lock.

Leveling and Final Tightening

Adjust the standard for squareness using a level and tighten the top bolt with an Allen wrench.

Installing into a Solid Door or Wall Studs

Standard Placement and Marking

Position the standard, use a level for squareness, and mark screw locations on the door or wall.

Drilling and Securing

Drill pilot holes with a 1/10" drill bit and secure the standard using wood screws.

Installing into a Hollow Door or Drywall

Standard Placement and Marking

Position the standard, ensure squareness with a level, and mark screw locations.

Drilling, Anchoring, and Securing

Drill holes for anchors, insert Hollow Door or Drywall Anchors, and tighten screws.

Adding Accessories to the System

Attaching Accessories

Align accessory tabs with standard slots and pull down to secure them in place.