ELICA THIN - Hood Operation; Control Panel and Indicators; Filter Saturation Alerts; Resetting Filter Indicators

31
Note : after the 30 minutes, the hood will go back to the
previously set intake speed ***
with the motor on “BOOST 1”, press T4 again to activate the
intensive intake speed “BOOST 2”, timed for 7 minutes
Note : after the 10 minutes, the hood will go back to the
previously set intake speed ***
Note : press T4 again, during the 7 minutes, to go back to the
previously set intake speed ***
with the “BOOST1” and “BOOST2” functions active, press:
to go back to the previously set intake speed
***
to go back to the 3rd intake speed
*** the previous intake speed remains visible via the indicator
LEDs L1
• if you have set the intensive speed directly with
the hood off, the motor will be turned off.
While using the “BOOST” functions, the T4 symbol flashes :
( “BOOST 1” : white light - “BOOST 2” : blue light)
Filter saturation indicators
At regular intervals, the hood signals the need to perform
maintenance on the filters.
LED (L1) on and flashing light (all indicator lights
flashing together) : perform maintenance on the grease
filter.
LED (L1) on and alternating light (the indicator lights
turn on in sequence): perform maintenance on the active
carbon filter
Note: The filter saturation indicator is visible within the
first 10 seconds on turning on the hood; the saturation
indicators must be reset within this time.
Reset filter saturation indicator:
Press and hold button
LED (L1) turns on and off (depending on the type of
filter being reset, the indicator lights flash together or turn
on in sequence); an acoustic signal will confirm the
operation.
Activation of filter saturation indicator
Note: this operation must be performed with the hood off.
- Grease filter
This indicator is normally activated
1st prolonged press of buttons and
if the indicator is active, button turns on
press button , to deactivate it
if the indicator is not active, button turns on
press button , to activate it
- Active carbon filter
This indicator is normally deactivated
2nd prolonged press of buttons and
if the indicator is active, button turns on
press button , to deactivate it
if the indicator is not active, button turns on
press button , to activate it