Eliet E450 - Page 35

35
English
• Placealevelobjectofapprox.4mmthickunderboth
front wheels.
• Turnthebladesmanuallyuntilthetipsareasclosetothe
surface as possible.
• Ifthebladestouchthesurfacetheymustbeliftedbyturning
the 2 depth adjustment knobs (to the left and right) anti-
clockwise until they are just above the surface level.
• Turnbothdepthadjustmentknobsclockwiseevenly.
• Thedepthsettingiscorrectwhenthebladesareonlyjust
above the surface.
• Checkthatthefrontsideofthescarierishorizontal;if
not, depth adjustment must be carried out again.
• Carefullyremovetheobjectsfromunderneathbothfrontwheels.
• Turntheplatebacktothefrontandthensecurethedepthadjustmentknobsinordertolock
the depth.
For your information:
If possibilities of front wheel depth adjustment are exhausted, the rear wheel
depth setting can be used.
Remove both back wheels. Remount the wheels, but this time in the highest (or
lowest) bolt holes. Now the blades will touch the surface again, hence the depth
setting on the front wheels must be fine-tuned.
Per set of blades, the adjustment on the rear wheels can be performed only
twice. If a new set of blades is applied, the rear wheels must be remounted into
the original bolt holes.