Need help?Do you have a question about the Elite access systems SL-3000-UL Series and is the answer not in the manual?
General guidelines for installing gate operators according to UL standards.
Guidelines for installing non-contact sensors like photo beams for gate operators.
Guidelines for installing contact sensors like edge sensors for gate operators.
Critical warnings and precautions to prevent injury or death during gate operation.
Classifications of gate operators based on usage type and location as per UL standards.
Describes entrapment hazards between gate and stationary objects during movement.
Details pinch point hazards in open rollers and between gate and rollers.
Explains crush hazards in picket gates and required screening.
Critical notice regarding gate post installation and clearance to prevent collisions.
Installer requirements for placing UL required warning signs for visibility and security.
Specifies that the SL-3000 series is exclusively for vehicular gate use, not pedestrian.
Visual guide illustrating recommended setup of gate components and safety features.
Emphasizes the need for a separate walkway for pedestrians.
Describes front installation type for gate operators, noting cost efficiency.
Details rear installation type, highlighting non-visible chain.
Explains ceiling mount underground installation, emphasizing space efficiency.
Instructions for connecting the chain for front gate installations.
Steps for modifying the cover for rear chain installation.
Illustrates correct gate and operator spacing for optimal function.
Shows incorrect gate and operator spacing that may cause issues.
Configuration for gate opening to the left side.
Configuration for gate opening to the right side.
Table specifying wire gauge requirements for different power supply distances.
Detailed instructions for proper earth ground rod installation for safety.
Setting the timer for automatic gate operation (1-60 seconds).
Setting the timer for push open/push close operation.
Adjusting sensor sensitivity to prevent false triggers or missed detections.
Adjusting sensor sensitivity for optimal gate system performance.
Setting the master timer for dual gate operation with timer enabled.
Setting the slave timer for dual gate operation with timer enabled.
Wiring diagram for connecting a solenoid lock to the J3 terminal.
Wiring diagram for connecting a magnetic lock to the J3 terminal.
Details the Quick Close Circuit, its modes, and application for slide gates.
Step-by-step installation guide for a three-push button control system.
Important information regarding loop perimeter, number of turns, and wire gauge.
Important information regarding loop perimeter, number of turns, and wire gauge.
Covers standard manual release, Model CP-17, and Model DC-1000U-SL options.
Explains the function and usage of the stop button for safety and alarm reset.
Best practices for installing edge sensors, including wiring, mounting, and placement.
Illustrates recommended layouts and connections for photocell and edge sensors.
Procedure for resetting the gate operator motor after thermal overload.
Troubleshooting steps when the gate fails to close, focusing on LED indicators.
Troubleshooting steps when the gate fails to open, focusing on LED indicators.
General| Brand | Elite access systems |
|---|---|
| Model | SL-3000-UL Series |
| Category | Gate Opener |
| Language | English |
To Next Page