1. With the viewing surface facing up, fold the fabric in half from top to bottom. When folding, make certain that
the viewing surface does not come into contact with the black binding, grommets or snap buttons. *Note: The
screens are shipped from production with tissue paper in the folds that should be retained for future use.
2. It is preferable to make sure that the first folds never exceed 3 feet in width (fold again if necessary). Also make
sure that there is always clean packing paper in between the two surfaces.
3. Larger sized screens will need to be folded with more frequency than smaller screens. Follow the instructions
from step 1 as well.
4. Fold the material from top to bottom first then alternate in folding left to right until the material is of a sufficient
size that will fit into the leatherette case.
Note:
Keep
the
screen
material
inside
its
case
when
not
in
use.
It will help protect the material from damage..
Cleaning
The screen surface can be cleaned as follows.
Use a clean white cloth (100% cotton preferred) and dampen it with clear purified water. Gently wipe in one direction
and NOT in a circular motion.
Use another dry cloth to dry after each cleaning session.
To remove a stubborn stain or sticky surface, use denatured alcohol (methanol or methyl alcohol) in lieu of water.
Attaching the Screen once it is unpacked
1. Use the snap buttons to connect the Screen material with the frame.
2. Start at the top working in whatever direction is most comfortable to you.
3. Stretch the corners if necessary to pair up the buttons with their corresponding snaps.
To Next Page
Loading...
Need help?
General
