25
Drips coming out of the
spout (4) at the end of
dispensing
This is not a fault. It is normal for a few drips to come out
at the end of dispensing.
Coffee dispensing does
not stop even if you press
the dispensing button
(2-3)
Faulty components Take the plug out of the socket and apply
to the service centre.
The machine has not been properly
rinsed after descaling
Rinse the machine again
The coffee dispensed has
an acid taste
Use of expired capsules Check the capsule expiry date
The capsule is not ejected
correctly
Capsule stuck in the infusion group
Close the lever (1) and open it again slowly
Press the dispensing button (2), and
slowly open the control lever (1) while
the water is being dispensed.
Capsule container (6) full
Make sure that the capsule container drawer
(6) does not contain too many old capsules,
preventing ejection of the used capsule;
empty it.
If the fault persists, apply to the service centre.
The capsule is not held in
the infusion group and falls
directly into the capsule
container (6)
Control lever (1) not
completely open
Completely open the control lever (1) so that
the capsule support comes out of its housing;
recover the unused capsule from capsule
container (6) and insert it again. If the fault
persists, apply to the service centre.
After having inserted the
capsule in the infusion
group, you cannot close
the control lever (1)
Capsule not aligned with the
infusion group
Open the control lever (1) and again and
then close it completely. If the fault persists,
apply to the service centre.
The coffee dispensed
by the machine is cold
Faulty boiler Apply to service centre
Capsule container (6) full Make sure that the capsule container drawer
(6) does not contain too many old capsules
and cannot take any more, then empty it.
Problem
Solution
Cause
To Next Page
Loading...
