11
2 Hold the bicycle with one hand and with the
other one unscrew the fastening screw , by
rotating the handle , until the bicycle itself is
freed, then remove the bike.
ATTENTION
1 The resistance unit becomes very hot while in
use. It is necessary to wait for it to cool down
before handling.
2 There are no singularly usable components in
the interior part. The warranty is cancelled if the
unit is opened or tampered with in any way.
3 The stand is intended to be used by a single
cyclist only.
4 Verify the safety and stability of the bike before
each training session.
5 The feet are built in a special anti-slip material,
so during the use there might be the chance that
they leave small traces on some floor surfaces.
6 If the quick release is not compatible with the
bushings of the stand, replace it with the one
supplied.
WE SUGGEST
Before each training session, clean the bicycle tyre
with water or cleaner.
If the pin of the quick release supplied (10) pro-
trudes from the locking nut by more than 3 mm,
cut off the protruding part (fig. 8).
ENGLISH
GB
8
To Next Page
Loading...
Need help?
General
