PARTS & FEATURES.. HOW TO USE..
Assembling for Use:
1. Wash all detachable parts and accessories and let dry completely before using
(see section ‘Cleaning’).
2. Place the Juice Collector (E)
Maxi-Matic is continuously improving our product development. This may result in slight variances between
the photography of the product on the packaging compared to the actual contents within the box.
onto the appliance (Fig. 1) and place the Pulp
Container (F) onto the appliance by tilting it forward slightly (2). Insert the top
end first and then push in the bottom end. (Fig.2)
3. Insert the Grater/Filter (D) into position inside the Juice Collector (E).
4. Place the Lid/Feeding Tube (B, C)
onto the machine properly.
Safety Clamp (J)5. Pull the locking lever
up and lock all parts into place. Make
sure the safety clamps are locked into the position on either side of the lid.
Note: The Pulp Container will remain loose.
6. Place the Juice Jug (L)
under the spout. (Fig.5)
Juice Jug (L)7. Place the lid on the
to avoid splattering or if you want to store the
juice in the refrigerator.
8. To separate the foam from the juice when pouring the juice into a glass, insert the
foam separator by sliding it into the juice jug. (Fig.6)
9. Now you can plug the power cord into a wall outlet.
A. Pusher H. Driving shaft
B. Feeding tube I. Motor unit
C. Lid J. Safety clamp
D. Grater Filter K. Juice jug lid
E. Juicer collector L. Juice jug (1Qt. Capacity)
F. Pulp container
G. Control knob
To Next Page
Loading...
