ELME 586TB - Twistlock Inspection and Greasing; Twistlock Replacement and Fitting

5 Loosen and remove the screw allen (item 5). Then remove the seated pin (item 6).
6 To give space, remove the two sensors (including hose clamps/brackets) by
loosening and removing the bolts and the washers (item 7).
7 Remove the bolt (item 8), the washer (item 9) and the lock washer (item 10).
Turn the twistlock cylinder away (item 11), to give space.
8 Remove the four bolts and washers (item 12) from the crank (item 13).
9 Li o the crank and remove the sleeve (item 14), the key (item 15) and the roll
pin (item 16) aached to the twistlock (item 17).
10 Remove the twistlock (item 17).
11 Finally, loosen and remove the bolts and the washers (item 18) from the twistlock
sleeve (item 19) and remove it.
Inspection/greasing prior to reassembly
12 Aer removal of all twistlock parts, remove all grease and dirt from the parts and
also from the corner of the head. Steam clean or clean with some form of solvent.
13 Check the twistlock (item 17) for wear on the head. The sleeve (item 14) and the
crank (item 13) should also be inspected for possible wear or damage and
replaced if necessary.
It should be noted that the state of the sleeve (item 14) and the recess in the
twistlock (item 17) is very important, as these parts are carrying the load when
 acontainerislied.
14 Before reassembling the twist lock parts, it is very important to plenful grease
the bushing inside the twist lock sleeve (item 19), the spacer (item 20) and the
surface it is placed on. Also grease the head of the twistlock (item 17) and inside
the tower (item 22) before mounng the seated pin (item 6).
15 It is also very important to plenful grease the surface both on top of and
underneath the area as shown on the gure on page 4 (item 21) before
reassembling.
Replacing / Fitting twistlocks
16 Replace/reassemble in reverse order, see above (from point 10 and backwards)
5