What to do if my Elmo Rietschle Blower is leaky?
If your Elmo Rietschle Blower is leaking, check the following: * Inspect the seals on the muffler and replace them if they are defective. * Inspect the seals in the motor area and replace them if necessary.
What does OC1 ?? (11) mean on my Elmo Rietschle G-BH1e Blower?
The error code OC1 ?? (11) on your Elmo Rietschle Blower indicates a short-circuit or excessive capacitive charging current. To address this: * Search for the cause of the short-circuit and check the motor cable. * If there's excessive capacitive charging current, use a shorter motor cable with lower charging current.
What does OC2 ?? (12) error mean on Elmo Rietschle Blower?
The error code OC2 ?? (12) on your Elmo Rietschle Blower suggests an earth fault or excessive capacitive charging current. The solution is: * Check for a grounded motor phase. * If the issue is excessive capacitive charging current of the motor cable, use a shorter motor cable with lower charging current.
What does OH4 ?? (54) mean on Elmo Rietschle G-BH1e Blower?
The error code OH4 ?? (54) on your Elmo Rietschle Blower indicates that the frequency inverter is too hot inside. To resolve this: * Reduce the frequency inverter load and improve cooling.
General| Brand | Elmo Rietschle |
|---|---|
| Model | G-BH1e Series |
| Category | Blower |
| Language | English |
Explains signal words, symbols, and abbreviations used in the manual.
Crucial safety and usage guidelines for the pump-motor unit.
Details potential hazards not entirely eliminated by safety measures.
Specifies intended use and limitations of the G-BH1e series blowers.
Lists prohibited uses and modifications of the pump-motor unit.
Physical specifications including weight, noise, and temperature increase.
Electrical specifications and requirements for the unit.
Conformity, vibration, site, and climatic conditions.
Describes equipment used for moving the pump-motor units.
Outlines methods for transporting the units manually or mechanically.
Covers general installation notes, free spaces, mounting, and final works.
How to attach mufflers to inlet and discharge connections.
Connecting inlet and discharge lines, including notes.
Procedures for electrical installation and wiring.
Essential steps and checks before starting commissioning.
How to configure the unit's parameters using the keypad.
Step-by-step guide to starting the unit after configuration.
Procedures for safely stopping the pump-motor unit.
Steps to prepare the unit before shutdown or long-term storage.
Guidelines for proper storage to prevent damage.
Guide to diagnosing and fixing malfunctions.
Information on professional service and support.
Procedures for cleaning units before service or return.
To Next Page
