Elo TouchSystems 3239L User Guide 31
interference, try to correct the interference by using one or more of the
following measures:
i) Move the digital device away from the affected
receiver.
ii) Reposition (turn) the digital device with respect
to the affected receiver.
iii) Reorient the affected receiver’s antenna.
iv) Plug the digital device into a different AC outlet
so the digital device and the receiver are on
different branch circuits.
v) Disconnect and remove any I/O cables that the
digital device does not use. (Unterminated I/O
cables are a potential source of high RF emission
levels.)
vi) Plug the digital device into only a grounded
outlet receptacle. Do not use AC adapter plugs.
(Removing or cutting the line cord ground may
increase RF emission levels and may also present
a lethal shock hazard to the user.)
vii) If you need additional help, consult your dealer,
manufacturer, or an experienced radio or televi-
sion technician.
III. Safety Label
The following marks have been issued for the unit and appear on the safety label as
shown in the illustration below:
Te st e d To C om p l y
With FCC Standards
FOR HOME OR OFFICE USE
301 Constitution Drive
LISTED
3Z74
E162681
ITE
lamp contains mercury - Dispose of properly
To Next Page
Loading...
Need help?
General
