To Next PageTo Next Page
Need help?Do you have a question about the Elson 120zi and is the answer not in the manual?
General| Brand | Elson |
|---|---|
| Model | 120zi |
| Category | Water Heater |
| Language | English |
Guidance on positioning the cylinder for optimal installation and performance.
Details on mains water pressure, flow rate, and connection requirements.
Recommendations for connecting hot and cold water outlets and pipework.
Details on pipe fittings, cold feed, drain tap, and outlet connections.
Information on the installation and function of the combination valve.
Details on the expansion vessel, its pre-charge, and connection.
Instructions for setting up a secondary circulation system.
Requirements for safe discharge pipe installation according to Building Regulation G3.
Extract from Building Regulation G3 regarding safe discharge of hot water.
Specifications for discharge pipes D1 and D2 from safety devices.
Essential safety precautions before commencing direct unit installation.
Guidance on electrical wiring and safety for direct units.
Required pipework connections for direct water heater units.
Essential safety precautions and electrical supply guidelines.
Pipework, boiler selection, and primary circuit control.
Information on space heating and hot water system controls.
Procedure for filling the unit with water and performing system checks.
Commissioning procedures for direct and indirect units.
Guidance on completing the Benchmark Installation, Commissioning and Service Record.
Requirements for maintenance and checking safety valve operation.
Maintaining strainer, immersion heaters, and unit specific tasks.
Checking expansion vessel pressure and re-commissioning.
User warnings, Benchmark scheme, and flow performance.
How to adjust temperature settings for direct and indirect units.
Information on common operational faults and their causes.
Key points to note before and after servicing the system.
Information on ordering authorised spare parts for the cylinder.
Guide to identifying and rectifying operational faults.
Warning against tampering with safety valves or controls.
Details on the product warranty terms and conditions.
Information about the heateam service division and its offerings.
Contact details for technical support and replacement parts.
Statement regarding continuous product development and specification changes.
