52 ESR Series Routers Operation Manual
For gi1/0/3 interface, specify 128.107.1.2/30 address and 'WAN' zone. R1 will be connected to the
Internet through this interface:
R1(config)# interface gi1/0/3
R1(config-if-gi)# security-zone WAN
R1(config-if-gi)# ip address 128.107.1.2/30
R1(config-if-gi)# exit
Create a route for interaction with 10.0.0.0/8 network using R2 device (192.168.100.2) as a
gateway:
R1(config)# ip route 10.0.0.0/8 192.168.100.2
Create a route for interaction with the Internet using provider gateway (128.107.1.1) as a nexthop:
R1(config)# ip route 0.0.0.0/0 128.107.1.1
Configuration changes on R1 router will take effect when the following commands are executed:
R1# commit
Configuration has been successfully committed
R1# confirm
Configuration has been successfully confirmed
R1#
Define the device name for R2 router:
esr# hostname R2
esr#(config)# do commit
R2#(config)# do confirm
For gi1/0/1 interface, specify 10.0.0.1/8 address and 'LAN' zone. R2 will be connected to 10.0.0.0/8
network through this interface:
R2(config)# interface gi1/0/1
R2(config-if-gi)# security-zone LAN
R2(config-if-gi)# ip address 10.0.0.1/8
R2(config-if-gi)# exit
For gi1/0/2 interface, specify 192.168.100.2/30 address and 'LAN' zone. R2 will be connected to R1
device through this interface for the subsequent traffic routing:
R2(config)# interface gi1/0/2
R2(config-if-gi)# security-zone LAN
R2(config-if-gi)# ip address 192.168.100.2/30
R2(config-if-gi)# exit
Create default route by specifying gi1/0/2 interface IP address of R1 router (192.168.100.1) as a
nexthop:
R2(config)# ip route 0.0.0.0/0 192.168.100.1
Configuration changes on R2 router will take effect when the following commands are executed:
R2# commit
Configuration has been successfully committed
R2# confirm
Configuration has been successfully confirmed
R2#
To Next Page
Loading...
