Need help?Do you have a question about the ELTEX ESR-1000 and is the answer not in the manual?
General| Device Type | Router |
|---|---|
| Firewall | Yes |
| Operating Temperature | 0°C to +40°C |
| WAN Ports | 2 x 10/100/1000BASE-T |
| VPN Support | IPSec, PPTP, L2TP |
| Supported Protocols | IPv4, IPv6, DHCP, DNS, NAT |
| Management | Web interface, CLI |
| Certifications | CE |
Guide to using the CLI for device management and monitoring.
Details default factory settings, security zones, and initial access parameters.
Describes connecting the router and performing basic configuration steps.
Procedures for updating firmware using TFTP, FTP, SCP, or SFTP.
Steps to update firmware using the bootloader.
Best practices for secure device operation, like disabling unused interfaces and NTP synchronization.
How to configure event logging for system monitoring and troubleshooting.
Guidelines for setting strong password policies and management.
Configuration for Authentication, Authorization, and Accounting services.
Recommendations and examples for secure remote access methods like SSH.
Steps to configure defenses against various network attacks like IP spoofing and SYN floods.
How to configure Virtual Local Area Networks for network segmentation.
Configuring Generic Routing Encapsulation tunnels for VPNs and traffic encapsulation.
Setting up Dynamic Multipoint Virtual Private Networks for scalable VPNs.
Configuring Layer 2 Tunneling Protocol Version 3 tunnels for L2 VPNs.
Configuring IPsec VPNs for secure data transfer with authentication, integrity, and encryption.
Configuring basic Quality of Service for traffic classification and queueing.
Advanced QoS configurations for traffic classification, policy creation, and bandwidth management.
Manually defining static routes for network traffic paths.
Configuring the Border Gateway Protocol for interdomain routing and exchange of reachability information.
Configuring Policy-Based Routing using route-maps for traffic redirection based on criteria.
Configuring the Label Distribution Protocol for MPLS tag distribution.
Configuring Layer 2 VPNs using Martini mode for ethernet frame transmission.
Configuring Layer 2 VPNs using Kompella mode, relying on BGP for pseudowire construction.
Configuring Layer 3 VPNs for distributed IP networks and traffic transfer within VRFs.
Configuring Authentication, Authorization, and Accounting for access control.
Assigning privilege levels to CLI commands for granular access control.
Configuring system logging and enabling defenses against various network attacks.
Setting up firewall rules for controlling traffic flow between security zones.
Creating lists of rules to define and filter network traffic.
Configuring Intrusion Prevention System/Intrusion Detection System for threat detection and prevention.
Restricting access to HTTP sites based on content categories.
Configuring the service to detect and filter unwanted email messages.
Configuring Virtual Router Redundancy Protocol for high router availability and gateway redundancy.
Configuring failover for firewall and NAT sessions to ensure service continuity.
To Next Page
