ESR series service routers.ESR-Series. User manual
Step Description Command Keys
9 Set the rule group scope. The rules 
will be applied only to traffic coming 
to a certain zone or interface.
esr(config-snat-ruleset)# to 
{ zone <NAME> | 
interface <IF> tunnel <TUN> | | 
default }
<NAME> – isolation zone name;
<IF> – device interface name;
<TUN> – device tunnel name
default – denotes a group of rules 
for all traffic, the source of which did 
not fall under the criteria of other 
groups of rules.
10 Specify a rule with a certain number. 
The rules are proceeded in 
ascending order.
esr(config-snat-ruleset)# rule 
<ORDER>
<ORDER> – rule number, takes 
values of [1..10000].
11 Specify the profile of IP addresses 
{sender | recipient} for which the rule 
should work.
esr(config-snat-rule)# match 
[not] 
{source|destination}-address 
<OBJ-GROUP-NETWORK-
NAME>
<OBJ-GROUP-NETWORK-NAME> – 
IP addresses profile name, set by the 
string of up to 31 characters.
'Any' value points at any source IP 
address.
12 Specify the profile of IP addresses 
{sender| recipient} for which the rule 
should work (optional).
esr(config-snat-rule)# match 
[not] 
{source | destination}-port 
<PORT-SET-NAME>
<PORT-SET-NAME> – port profile 
name, set by the string of up to 31 
characters. 'Any' value points at any 
source TCP/UDP port.
13 Set name or number of IP for which 
the rule should work (optional).
esr(config-snat-rule)# match 
[not] 
{protocol|protocol-id} <TYPE>
<TYPE> – protocol type, takes the 
following values: esp, icmp, ah, eigrp, 
ospf, igmp, ipip, tcp, pim, udp, vrrp, 
rdp, l2tp, gre. 'Any' value points at 
any protocol type.
<ID> – IP identification number, 
takes values of [0x00-0xFF].
14 Specify the type and code of ICMP 
messages for which the rule should 
work (optional).
esr(config-snat-rule)# match 
[not] 
icmp 
{<ICMP_TYPE><ICMP_CODE> | 
<TYPE-NAME>}
<ICMP_TYPE> – ICMP message 
type, takes values of [0..255].
<ICMP_CODE> – ICMP message 
code, takes values of [0..255]. 'Any' 
value points at any message code.
<TYPE-NAME> – ICMP message 
type name