model AMP 500/1
subwoofer amplifier
POWER
EQ 1
EQ 3
POWER MODE
EQ 2
SPEAKER OUTPUT
LINE IN
L
R
LFE IN
CROS SOVER PHAS E
(Sub 1 +Sub 2) m inimu m 4Ω
Total I mpeda nce
SUB 1
+
-
SUB 2
+
-
DC 12V
IN
OUT
AUTO
ON
SETTINGS
VOLUME
TRIGGER
50 200 0° 180°
S/N:
Overview.
Thank you for purchasing Elura
Amplifier products. Elura is a high
performance custom installed
product engineered for movie and
music enthusiasts. Each Elura
product is manufactured to the
highest quality standard using state
of the art components and built for
years of enjoyment.
Features.
• Digital high power amplification
• 4 Ohm Impedance Capable
• Thermal & Short Circuit
Protection
• Low Noise
• Small chassis
• Less Heat
• Efficient Class D design
• Rack mountable
• Automation circuit
• Detachable Power Cord
Contents.
• Amplifier
• Rack Mounting Hardware
• Power cord
• Manual
Warning.
T
o reduce the risk of electric shock,
do not expose this product to rain or
moisture. This product should not
be exposed to dripping or splashing
and avoid placing near any object
filled with water, such as a vase or
an aquarium.
Important Symbols.
The lighting flash arrowhead
triangular symbol is to alert the user
to the presence of uninsulated
‘dangerous voltage’ within the
product sufficient enough to
constitute a risk of electric shock.
The arrowhead symbol with an
exclamation point is to alert the user
to the presence of an important
operational or maintenance
instruction.
Safety Instructions.
1. Read the instructions.
2. Keep the instructions.
3. Heed all warnings.
4. Follow the instructions.
5. Do not use near water.
6. Clean with a dry cloth.
7. Do not block ventilation slots.
8. Install in accordance to the
instructions.
9. Do not install near a heat source
or combustible source.
10. Do not defeat the polarized or
grounding plug.
11. Protect the power cord from
being crimped, cut or pinched.
12. Only attached accessories
specified within the instructions.
13. Use only on lower shelves with
a stand, cart or rack product
capable of holding the weight to
avoid injury from furniture tipping
over.
model AMP 500/1
subwoofer amplifier
www.elura.audio
Specifications.
Output Power: Line & LFE 500W @ 4Ω
Line & LFE 330W @ 6Ω
Line & LFE 250W @ 8Ω
THD+N: Line & LFE @4Ω=0.04%
Input Sensitivity: Line 124mV / LFE 162mV
Frequency Response: Line 15Hz - 260Hz / LFE 15Hz - 550Hz
Low Pass Crossover: 1W/4Ω 90Hz = 0-3dB, 90Hz - 260Hz
Low Pass Filter: 1W/4Ω, 260Hz=0dB, test point @ 525Hz, 13dB/Octave
Signal to Noise Ratio: 500W @4Ω / 90Hz, 90dB, 1W @4Ω / 90Hz, 65dB
Auto Turn Off Time: 16 min
Supply Voltage: AC230V / 50Hz, AC115V / 60Hz
To Next Page
General