7. MAINTENANCE
Please note that the following maintenance intervals apply for normal operating conditions only. If your daily work
requires longer than normal or harsh cutting conditions are present, then the suggested intervals should be shortened
accordingly.
Complete Machine
Inspect (Leaks, Cracks, and Wear)
x
x
x
x
x
x
x
x
x
x
x
x
x
x x
x
x
x
x
x
x
x
x
x
x
Clean after finishing daily work
Check Operation
Inspect (Leaks, Cracks, and Wear)
Inspect
Clean
Controls (STOP button, Choke Lever, Throttle
Trigger, Trigger interlock)
Fuel Tank
Fuel Filter and tube
All Accessible Screws and Nuts (Not Adjusting Screws)
Air Filter
Before Each Use
Monthly
As Required
1 year or 100 hrs.
Cylinder Fins
Starter System Vents
Carburetor
Spark Plug
Vibration Mounts
Attachments coupling
Clean, Replace Filter Element
Inspect
Retighten
Clean
Clean
Clean after finishing daily work
Replace
Check Electrode Gap
Inspect (Damage, and Wear)
Replace by Dealer
Grease
Replace
Check Idle (Cutting Attachments must not
rotate at idle)
Replace
Maintenance Chart
x
Inspect (Damage, and Wear)
Starter Rope
x
If Damaged or
Faulty
22
GB
To Next Page
Loading...
Need help?
General