emaux SSC mini - Water Chemistry; Salt Level

4
near flammable materials.
This equipment should never be installed in places susceptible to flooding.
It is important to reduce chlorine production properly while the pool is covered. Otherwise, an excess of
chlorine could degrade the pool materials.
6. WATER CHEMISTRY
The following table shows the recommended levels of the chemical parameters required for a proper quality
of water in the pool by using Emaux SSCmini
®
.
Test your water periodically and ensure the levels are within the recommended range.
Salt Level
4000 – 6000 ppm
Free Chlorine
1.0 – 3.0 ppm
pH Value
7.2 – 7.6
Cyanuric Acid (stabilizer)
30 – 50 ppm
Total Alkalinity
80 – 120 ppm
Calcium Hardness
200 – 400 ppm
Metal
0 ppm
6.1 SALT LEVEL
The amount of salt required when using Emaux SSCmini
®
is between 4000 and 6000 ppm. To reach
this concentration, it is necessary to 4 kg of salt per each cubic meter of pool water.
Low salinity (below 2500ppm) will cause premature cell failure. High salinity (above 6000ppm) will result
in electro-oxidation and the corrosion of stainless steel swimming pool fixtures.
Salt required according to the pool volume:
Pool volume (m
3
)
Salt (kg)
Pool volume (Gallon)
Salt (Pound)
10
40
2,642
88
15
60
3,963
132
20
80
5,283
176
25
100
6,604
220
30
120
7,925
264
35
140
9,246
308
40
160
10,567
352
50
200
13,209
440
60
240
15,850
528
70
280
18,492
616
80
320
21,134
704
90
360
23,775
792
100
400
26,417
880
Note: Table based on 4000 ppm of salt per m
3
of water.