②Move the “Master” slider to MAXIMUM
Apply power to your ship so that all ESC’s are powered. When your ESC’s play their intital tune, move throttle
“Master” quickly to the bottom. You will then hear a confirmation tune. When the tune ends the ESC calibration is
completed. If an ESC continues to beep, unplug the power and start over.
4. Select Mode
Switching interface into Mode selection.
①Modes: ARM, ANGLE, HORIZON, MAG, HEADFREE, etc. To add a mode click “Add Range” and then assign
channel. AUX1 is channel 6 and AUX2 is channel 7.
②Channel Select for Modes.
Click “Add Range”button under any mode to add flight mode. Then select a channel in the drop-down
box as channel for that mode.Then check the box and save the setting by click "SAVE" at right bottom
corner. If the corresponding flight mode of selected channel is active. Then when switching to the
channels, flight Modes Options screen will be highlighted green. Other will highlighted red on the
screen. Red LED also indicates whether the it is active or not(red light means that the selected flight
mode is not active). Some models will be based on hardware sensors access situation to decide whether
to display. For example, with hardware without a barometer module ,Altitude hold will not be available.
Some modes need to be selected at the same time to function correctly.
5. Receiver Calibration
1.***Please remove ALL propellers for these steps.
2 Go to the Receiver tab. Connect power to the flight controller and power on your RC transmitter.
To Next Page
Loading...
