9
We recommend connecting any home theater media center computers,
or appliances containing a hard drive into the ‘Always On’ sockets. We
recommend connecting home theater projection equipment which require
a cool down period to the 'Always On' sockets. This will prevent damage to,
and extend the life of your home theater projection lamps.
The Embertec Emberstrip™ AV
+
has 2 power
saving functions
1. Standby Powerdown automatically detects and saves power wasted
when equipment is left in standby mode, by switching the power off to
the equipment.
2. Active Powerdown™ automatically switches the power off to Audio Visual
(AV) equipment connected to the 'Power Saver' socket after 1 hour, if it
has not detected any remote control use.
NOTE: The Embertec Emberstrip™ AV
+
is programmable and has an Active
Powerdown™ default setting of 1 hour, which can be permanently set to
2 hours, or temporarily 8 hours (MusicMode™).
When will Active Powerdown™ Switch the Audio
Visual (AV) Equipment off?
• If your Embertec Emberstrip™ AV
+
detects that your Audio Visual (AV)
equipment is on but has not been used for a period of 1, 2 or 8 hours
(depending on your settings), the LED light on the SmartSensor will flash
for approximately 10 minutes to warn you that power down is imminent.
To continue using your equipment.
• Simply press the volume button on ANY of your existing remote controls
or press the button on the SmartSensor once. This will cancel the Active
Powerdown™ and reset the timer to 1, 2 or 8 hours (according to your setting).
NOTE: A flashing LED always means that your system will shut down
completely in a while. Press any remote control button to stop the light
flashing and continue using your system.
Press button on
the SmartSensor.
A flashing light means
the system is getting
ready to shut down.
TO CONTINUE
USING YOUR
EQUIPMENT
Press the volume
button on your
remote control.
To Next Page
Loading...