GROUND SERVICING
AIRPLANE
OPERATIONS
MANUAL
1-12-60
Page
20
Code
01
TEMPORARY REVISION 41.1
Copyright © by Embraer. Refer to cover page for details.
AOM-145/1114
ATA
EICAS
MESSAGE
or
CONDITION
LOCATION PROCEDURE
34
AHRS 1
FAIL
(continued)
EICAS
(continued)
Operator can change the
present position coordinates
via the bezel pushbuttons
and the data set knob.
(b) After the present coordinates
are set, push the ENT
pushbutton to send the
coordinates to the AH-900
computer.
For airplanes with single or dual
Universal FMS:
NOTE: Operator can use either
the FMS CDU or the bezel
pushbuttons of the pilot’s MFD to
enter the present position.
(a) FMS CDU:
On the FMS CDU, on the INIT
1/1 page, push the ACCEPT
line select key to update the
FMS position.
Bezel pushbuttons:
Make sure that the airplane is
in the ground configuration.
On main menu of the pilot’s
MFD, use the bezel
pushbuttons to select the
PPOS INIT option (pilot’s MFD
shows the present position
initialization menu).
NOTE: From this menu
operator can:
Confirm that the EFIS
stored present position
(PPOS) is correct, and push
the ENT pushbutton, or
(continued)
To Next Page
