Embraer EMB145 - Page 1346

AIRPLANE
OPERATIONS
MANUAL
GROUND SERVICING
REVISION 41
1-12-60
Page
13
Code
01
Copyright © by Embraer. Refer to cover page for details.
AOM
-
145/1114
ATA
EICAS
MESSAGE
or
CONDITION
LOCATION PROCEDURE
34
M Flag on
the ISIS
ISIS
(1) On the circuit bre
aker panel, open
and close the INTEG STBY circuit
breaker.
NOTE: Before turning on the
ISIS, make sure that there is no
dynamic pressure applied to
Pitot/Static 3. It must be
equivalent to an airspeed equal to
or greater than 60 knots.
The airplane must be maintained
stationary during the ISIS
initialization.
(2)
The display shows an initialization
page for 90 seconds.
(3) Wait until the ISIS completes its
initialization.
34
MAINT
Indication
on the ISIS
ISIS
(1)
On the circuit breaker panel, open
and close the INTEG S
TBY circuit
breaker.
NOTE: Before turning on the
ISIS, make sure that there is no
dynamic pressure applied to
Pitot/Static 3. It must be
equivalent to an airspeed equal to
or greater than 60 knots.
The airplane must be maintained
stationary during the ISIS
initialization.
(2)
The display shows an initialization
page for 90 seconds.
(3) Wait until the ISIS completes its
initialization.