AIRPLANE
OPERATIONS
MANUAL
NORMAL PROCEDURES
REVISION 37
1-02-17
Page
9
Code
02
AOM-145/1114
DIGITAL AUDIO Panel ............................................... AS REQUIRED
Select the microphone and audio reception buttons as required and
adjust the volume levels.
Reversionary Panels................................................... NORMAL
Both pilots must check that their respective MFD Selector Knobs
are set to NORM.
Flight Instruments ....................................................... SET &
X-CHECKED
Both pilots must set their respective altimeters to the local QNH.
They must also select an initial course as per the expected
departure procedure. The CPT must also set the HDG bug
according to the intended runway heading.
Once these actions are complete, the pilots must carry out an
instrument crosscheck as follows:
- Both AIRSPEED TAPES not showing speed;
- EADI’s level and flag-free;
- Both ALTIMETERS with their QNH set, and reading
consistent with altitudes. If the crew already has the
predeparture clearance, they can select the initial assigned
altitude on the ASEL;
- Both VERTICAL SPEED INDICATORS showing zero;
- EHSI’s with the courses selected according to the intended
departure procedure, showing the same magnetic heading,
flag-free and with the heading bug set to the intended
runway heading.
NOTE: In case of heading split, check if there are ferrous structures or
other magnetic interference sources close to the airplane,
and/or move the airplane to a different location.
To Next Page
Loading...
