Throughput
Displays throughput numbers for the cluster as <in> | <out> | <total>.
Node
The Node menu contains the following sub-menus:
Details
Displays the node ID, the node serial number, the health status of the node,
and the node uptime as <days>, <hours>:<minutes>:<seconds>
Capacity
Displays the total capacity of the node and the percentage of used and
available space on the node.
Network
Displays the IP and MAC addresses for the node.
Throughput
Displays throughput numbers for the node as <in> | <out> | <total>.
Disk/CPU
Displays the current access status of the node, either Read-Write or Read-Only.
Also displays the current CPU throttling status, either Unthrottled or Throttled.
Drives
Displays the status of each drive bay in the node.
You can browse through all the drives in the node with the right and left navigation
buttons.
You can view the drives in other nodes in the cluster with the up and down
navigation buttons. The node you are viewing will display above the drive grid as
Drives on node:<node number>.
Hardware
Displays the current hardware status of the node as <cluster name>-<node
number>:<status>.
Also displays the Statistics menu.
Statistics
Displays a list of hardware components. Select one of the hardware
components to view statistics related to that component.
Update menu
The Update menu allows you to update OneFS on the node. Press the selection button to
confirm that you would like to update the node. You can press the left navigation button
to back out of this menu without updating.
Service menu
The Service menu contains the following sub-menus:
Throttle
Displays the percentage at which the CPU is currently running.
Press the selection button to throttle the CPU speed.
Install a new node
Front panel LCD menu 17
To Next Page
Loading...
Need help?
General