EMC VNX VG8 - Page 12

EMC VNX VG2/VG8 Gateway Configuration Setup Guide
12
Preface
EMC CONFIDENTIAL
Chapter 9, “Install and Configure EMC NAS Software,” explains how to install and
configure the EMC NAS software on the Control Station and blades. It also explains
how to complete array configuration.
Part 3: Appendixes
Appendix A, “Change ConnectHome Dialing Configuration,” explains how to
modify the ConnectHome configuration for customers outside the United States and
Canada, and for customers with certain telephone systems.
Appendix B, “Change IP Addresses,” explains how to change the private IP
addresses of the VNX server after installation.
Appendix C, “Backend Storage Requirements Check Failed Error,” explains how to
correct the
Backend Storage Requirements Check Failed error by upgrading the
software on the VNX server or VNX array.
Appendix D, “Resolve Blade Boot Failures,” explains how to troubleshoot and fix the
cause of a blade not booting from an array. Potential problems include downlevel
firmware on the blade and damaged optical cables.
Appendix E, “NAS Install Options,” explains how to use the kickstart installation
procedure. Instead of entering configuration information interactively during a
software installation, you enter the values into a file in advance. The software
installation can then run without stopping to prompt you for information.
Appendix F, “Manually Zone Switches and Configure System LUNs,” explains how
to manually configure the system’s LUNs, including the RAID group and storage
group on a VNX boot array. It also explains how to manually zone the Fibre Channel
switches used to connect the VNX gateway to its boot array.
Appendix G, “Cable Connections from Fibre Channel Switch to Storage Array,”
explains how to cable the VNX gateway to legacy backend arrays.
Appendix H, “Setup Worksheets,” provides an easy way to collect and record
configuration settings before starting the installation.
Appendix I, “Navisphere Manager procedures,” provides procedures for VNX
backend systems that have FLARE versions prior to R30.