Preface
As part of an effort to improve its product lines, EMC periodically releases revisions of its
software and hardware. Therefore, all versions of the software or hardware currently in
use may not support some functions that are described in this document. The product
release notes provide the most up-to-date information on product features.
Contact your EMC technical support professional if a product does not function correctly
or does not function as described in this document.
This document was accurate at publication time. Go to EMC Online Support (https://
support.emc.com) to ensure that you are using the latest version of this document.
Purpose
This publication describes how to configure and install a new Avamar Data Store (ADS)
Gen4S single-node server. Implementation is typically performed remotely by EMC
personnel.
Audience
The information in this publication is primarily intended for persons responsible for
configuring and installing ADS Gen4S.
Installation in this context is the physical rack and stack, power, cable, and initial
network configuration required to facilitate software implementation done by EMC
personnel or an authorized partner. EMC field personnel and partners should use SolVe
Desktop documentation.
Revision history
The following table presents the revision history of this document.
Table 1 Revision history
Revision Date Description
01 October 25, 2012 Q4 Data Store Release 01 version.
02 February 11, 2013 Gen4S General Availability Release 02 version.
03 July 10, 2013 Initial release of Avamar 7.0
04 May 9, 2016 Avamar 7.3 and Gen4T General Availability
Related documentation
The following EMC publications provide additional information:
l
EMC Avamar Data Store Customer Service Guide
Special notice conventions used in this document
EMC uses the following conventions for special notices:
Indicates a hazardous situation which, if not avoided, results in death or serious injury.
EMC Avamar Data Store Gen4S Customer Installation Guide 5
To Next Page
Loading...