SMOKE ALARM USER MANUAL
DESCRIPTION
The unit is a photoelectric smoke alarm device. It is particularly sensitive for detecting visible
micro-particles (associated with smoldering fires) and reacts faster than ionization alarms.
An example of such smoldering fires is a cigarette burning in a couch or bedding, a common cause
of devastating blazes.
Please note this device does not detect flames, heat, carbon monoxide or other hazardous gases.
It has many advanced features and an extended operational life with the included battery.
MODEL NUMBER: EP-RANG-RF-10
Thank you for choosing Emerald Alarms.
This leaflet contains important information on the correct
installation and operation of your smoke alarm.
Please read all the information before commencing
installation and retain for future reference.
This unit has been designed to meet the latest
safety standards demanded in Australia and
complies with the requirements of AS3786:2014.
POWER: built-in DC3V (CR17450) 10 years Lithium battery
(non-replaceable battery)
OPERATION CURRENT: <8uA (standby) <60mA (alarm)
BATTERY LIFETIME: 10 years
ALARM VOLUME: 85dB (A) at 3 meters
ALARM SENSITIVITY: 0.1-0.16dB/m
HUSH/SILENCE TIME: approx. 8 minutes
INTERCONNECTION: up to 40 smoke alarm/s, wireless
COMPLY WITH: AS3786: 2014
SOUND PATTERN: ISO8201 (Bl 0.5s - pause 0.5s - Bl 0.5s - pause 0.5s - Bl 0.5s - pause 1.5s,
with the red LED flash, repeat this alarm pattern
WIRELESS INTERCONNECTION
Bl - Bl - pause 0.5s, Bl - Bl - pause 0.5s, Bl - Bl - pause 1.5s,
ALARM SOUND PATTERN: without the red LED flash, repeat this alarm pattern
To Next Page
Need help?
General
