Emerson EWC27T4 - Selecting the Mts System

- 24 - EN
1C29
SELECTING THE MTS SYSTEM
Make sure ...
•
TV/VCR/DVD power must be turned on.
TO SELECT HIFI MODE
1
Select “USER’S SET UP”
Press the SETUP button on the
remote control.
Press the Arrow button K or L to
point to “USER’S SET UP”. Then
press the ENTER button.
2 Select“VCR AUDIO”
Press the Arrow button K or L to
point to“VCR AUDIO”.
3 Select [HIFI]
Press the ENTER button until
[HIFI] appears.
4 To return to TV mode
Press the SETUP button on the remote control to
return to TV mode.
NOTES:
•
Normally “HIFI” should be selected for playback
with HIFI sound.
•
When you play non-HIFI tapes, the TV/VCR/DVD
will play automatically in the monaural mode.
•
The TV/VCR/DVD records automatically MTS
broadcasts in HIFI stereo sound unless you select
SAP mode recording before you begin recording.
TO SELECT STEREO, SAP, OR MONO
1
Select “USER’S SET UP”
Press the SETUP button on the
remote control.
Press the Arrow button K or L to
point to “USER’S SET UP”.
2 Select “TV AUDIO”
Press the Arrow button K or L to
point to“TV AUDIO”.
3 Select [STEREO], [SAP], or [MONO]
Press the ENTER button until [STEREO], [SAP], or
[MONO] appears.
4 To return to TV mode
Press the SETUP button on the remote control to
return to TV mode.
NOTES:
•
You must select the recording mode,either TV
AUDIO [STEREO] or [SAP] when you record a
broadcast.
Refer to
“MTS RECORDING/MONITOR
MODE”.
•
If you select second audio when second audio is
not available, the TV/VCR/DVD will record nor-
mal audio.
•
The TV/VCR/DVD records automatically MTS
broadcasts in HIFI stereo sound unless you select
SAP mode recording before you begin recording.
- TV/VCR SETUP -
TIMER PROGRAMMING
SETTING CLOCK
CHANNEL SET UP
B USER’S SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
- TV/VCR SETUP -
TIMER PROGRAMMING
SETTING CLOCK
CHANNEL SET UP
B USER’S SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
– USER’S SET UP –
RENTAL [OFF]
REPEAT PLAY [OFF]
AUTO RETURN [OFF]
B VCR AUDIO [HIFI]
TV AUDIO [STEREO]
– USER’S SET UP –
RENTAL [OFF]
REPEAT PLAY [OFF]
AUTO RETURN [OFF]
VCR AUDIO [HIFI]
B TV AUDIO [STEREO]
– USER’S SET UP –
RENTAL [OFF]
REPEAT PLAY [OFF]
AUTO RETURN [OFF]
B VCR AUDIO [HIFI]
TV AUDIO [STEREO]
TO SELECT MONO MODE
You can change the selection to “MONO” if you
want to listen to HIFI tapes in normal audio play-
back.
1) Press the SETUP button on the remote control.
Press the Arrow button K or L to point to “USER’S
SET UP”. Then press the ENTER button.
2) Press the Arrow button K or L to point to
“VCR AUDIO”.
3) Press the ENTER button until [MONO] appears.
4) Press the SETUP button on the remote control to
return to TV mode.
TV/VCR