5-2 L6118EA
3-1. Setting for 7F and FRENCH
Data Values
General
1. Enter the Service mode. (See page 5-1)
2. Press "VOL p" button on the Service remote con-
trol unit. Display changes "C/D," "VCO," "7F,"
"FRENCH," "ACCESS CODE," "STEREO," "VID-
EO TONE," "FM-MODE" and "AV-OUT" cyclically
when "VOL p" button is pressed.
7F
1. Press "VOL p" button on the Service remote con-
trol unit. Then select 7F display.
2. Press "CH o / p" buttons on the Service remote
control unit. Then choose 7F=FF.
FRENCH
1. Press "VOL p" button on the Service remote con-
trol unit. Then select FRENCH display.
2. Press "CH o / p" buttons on the Service remote
control unit. Then choose FRENCH=OFF.
When CPU version is 053-0.10, perform the follow-
ing settings:
ACCESS CODE ---- set to OFF
VIDEO TONE ---- set to OFF
FM-MODE ---- set to OFF
AV-OUT ---- set to OFF
STEREO ---- set to ON
Note:
C/D
and
VCO
data values do not need to be
adjusted at this moment.
3-2. Setting for CONTRAST,
COLOR, TINT, V-TINT and
SHARP Data Values
General
1. Enter the Service mode. (See page 5-1)
2. Press "MENU" button on the Service remote control
unit. Display changes "BRIGHT," "CONTRAST,"
"COLOR," "TINT," "V-TINT " and "SHARP " cycli-
cally when "MENU" button is pressed.
CONTRAST (CNT)
1. Press "MENU" button on the Service remote control
unit. Then select " CONTRAST " (CNT) display.
2. Press "CH o / p" buttons on the Service remote
control unit so that the value of "CONTRAST"
(CNT) becomes 78.
COLOR (CLR)
1. Press "MENU" button on the Service remote con-
trol unit. Then select "COLOR" (CLR) display.
2. Press "CH o / p" buttons on the Service remote
control unit so that the value of "COLO " (CLR) be-
comes 58.
TINT (TNT)
1. Press "MENU" button on the Service remote con-
trol unit. Then select "TINT" (TNT) display.
2. Press "CH o / p" buttons on the Service remote
control unit so that the value of "TINT" (TNT) be-
comes 60.
V-TINT (V-TNT)
1. Press "MENU" button on the Service remote con-
trol unit. Then select "V-TINT" (V-TNT) display.
2. Press "CH o / p" buttons on the Service remote
control unit so that the value of "V-TINT" (V-TNT)
becomes 62.
SHARP (SHARP)
1. Press "MENU" button on the Service remote con-
trol unit. Then select " SHARP " (SHARP) display.
2. Press "CH o / p" buttons on the Service remote
control unit and select "SHARP OFF."
Note:
BRIGHT
data value does not need to be adjust-
ed at this moment.
To Next Page
Loading...
Need help?
General
