Select a spot under the sink to mount
tank vertically within reach of both
plumbing and electrical connections.
The tank should be within 16" or less
of faucet water lines and within 30"
or less of a standard grounded outlet.
While holding tank in place on
the spot selected for installation,
use a pencil to mark locations for
2 hanging screws.
Property Damage: Tank must be located
within 16" of faucet and within 30" or less
of a standard grounded outlet. DO NOT extend
plumbing or electrical lines.
3
Without depressing the gray button,
place the snap-connect fitting at
the end of the blue 1/4" tube onto
the left fitting on the tank, pushing
until it clicks into place. (1)
Slip the flexible white 7/16" tube
over barbed middle fitting and slide
down approximately 1/2". (2)
Slip the clear 5/16" tube over the
far right smooth fitting and slide
down approximately 1/2". (3)
Visually check for pinched or
crimped tubes.
4
Property Damage: Pinched or blocked water
lines may cause damage to the dispenser tank.
Check to make sure tubes are connected
properly and are pushed down as far as possible.
Tank must be
mounted level
to ensure
proper operation.
Hose clamps are not needed for any
of the connections.
Mount tank vertically in an area that
allows clearance on the underside of
the tank for drainage, if necessary.
DO NOT over tighten screws.
Pre-drill 1/8" pilot holes at marks.
Turn screws into pre-drilled holes,
leaving 1/4" exposed.
Hang the tank on the screws.
Tighten the screws with only 1/2
turn clockwise.
Screws provided are for use in wood
studs or cabinets only. Use wall anchors
(not supplied) for installation into drywall.
Leave 1/4" for
hanging tank.
Brass Nut
Plastic
tube
tube
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Wing Nut
Fiber
Washer
Wing Nut
Fiber
Washer
Fiber
Washer
Star Nut
Fiber
Washer
1
2
3
Star Nut
Fiber
Washer
Star Nut
Copper
Brass Nut
Ferrule
Brass Nut
Plastic
tube
tube
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Wing Nut
Fiber
Washer
Wing Nut
Fiber
Washer
Fiber
Washer
Star Nut
Fiber
Washer
1
2
3
Star Nut
Fiber
Washer
Star Nut
Copper
Brass Nut
Ferrule
Brass Nut
Plastic
tube
tube
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Wing Nut
Fiber
Washer
Wing Nut
Fiber
Washer
Fiber
Washer
Star Nut
Fiber
Washer
1
2
3
Star Nut
Fiber
Washer
Star Nut
Copper
Brass Nut
Ferrule
(1) (2) (3)
MOUNTING THE TANK
CONNECTING FAUCET TO TANK
Make sure to use fiber gasket
to ensure proper seal.
Unpack dispenser components.
On a firm, flat surface, carefully
straighten the copper tubing using
hands only.
Ensure that the fiber gasket is
properly seated against the base
of the dispenser head.
2
H770
H770
From below the sink, place semi-
circular metal mounting plate over
the mounting screw, ensuring the
mounting plate covers the sink hole.
Slide washer over so that the screw
is now inside the smaller hole.
Tighten the screw until snug.
Feed tubes down the hole in
the sink or countertop until the
base is at rest on the sink or
countertop surface.
Position faucet head at the
desired angle.
Half moon shaped metal mounting plate
should cradle all descending tubes.
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
H770
H770
DO NOT remove mounting screw or
fiber gasket from base of dispenser.
Brass Nut
Plastic
tube
tube
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Wing Nut
Fiber
Washer
Wing Nut
Fiber
Washer
Fiber
Washer
Star Nut
Fiber
Washer
1
2
3
Star Nut
Fiber
Washer
Star Nut
Copper
Brass Nut
Ferrule
Brass Nut
Plastic
tube
tube
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Wing Nut
Fiber
Washer
Wing Nut
Fiber
Washer
Fiber
Washer
Star Nut
Fiber
Washer
1
2
3
Star Nut
Fiber
Washer
Star Nut
Copper
Brass Nut
Ferrule
Brass Nut
Plastic
tube
tube
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Wing Nut
Fiber
Washer
Wing Nut
Fiber
Washer
Fiber
Washer
Star Nut
Fiber
Washer
1
2
3
Star Nut
Fiber
Washer
Star Nut
Copper
Brass Nut
Ferrule
INSTALLING THE FAUCET - H770
Brass Nut
Plastic
tube
tube
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Wing Nut
Fiber
Washer
Wing Nut
Fiber
Washer
Fiber
Washer
Star Nut
Fiber
Washer
1
2
3
Star Nut
Fiber
Washer
Star Nut
Copper
Brass Nut
Ferrule
Brass Nut
Plastic
tube
tube
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Wing Nut
Fiber
Washer
Wing Nut
Fiber
Washer
Fiber
Washer
Star Nut
Fiber
Washer
1
2
3
Star Nut
Fiber
Washer
Star Nut
Copper
Brass Nut
Ferrule
Brass Nut
Plastic
tube
tube
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Wing Nut
Fiber
Washer
Wing Nut
Fiber
Washer
Fiber
Washer
Star Nut
Fiber
Washer
1
2
3
Star Nut
Fiber
Washer
Star Nut
Copper
Brass Nut
Ferrule
a
a
b
b
a
C
d
Fiber
Gasket
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
9
8
To Next Page
Loading...
Need help?
General
