10
PREPARATION
Before you connect:
Be sure your antenna or other device s connected properly
before plu_ng In the AC bower cord.
Antenna Connection
Connect the Ri eoa×lal cable o _our home outlet to the
_R]_enna IRDU_ ark of this unit
VHF/UHF
analogor
DTV antenna
®
®
®
@
®
@
®
®
®
®
@
_,Fcoaxial cable
cable TV signal
Once connect ons are completed,turn on the unt and begin
nitial setup. Channel scann ng s necessary for the unit to
memorize all available channels n your area. [initial Setup]
_,! p.11
No(,
If you have any quest on about the ©TV's antenna, vsit
www.antennsweb.o% for further nformation.
Depending on your antenna system, you may need d fi_,rc,nt types
of comb nets (mixers) ol- separsJtors (sp tters) for HDTV signa
the rain mum RF bandpass or, these devces is 2,000bqHz ol- 2GHz,
For your safe'ty nd to dvod damage to this unt, please unpug the
RF coaxa cable flsm the antenna input jack before movng the
unit.
If you did use an antenna to rece ve ann ogTV, t should aso
wofl< for DTV mcept on, Outdoor or stt}c antennas w be more
eff_,ct ve than a sot top or inside antenna.
lb switch your mcept on source easily br,tween antenna and cabe,
nstall an antenna selectoE
If you a_c,not receiv ng a sgna flsm your cable serv re, contact the
Cabe prov de_:
Connection to Cable Receiver or
Satellite Box
Use an HDhql or ComponentV deo cables to connect the
HDMI or the ComponentV deo input jacks of the unit to the
HDPll or the ComponentV deo output jacks of the cable
race ver/satellite box.
if you connect to the unit's ComponentVideo input jacks,
connect Analog Audio cables to the Analog Audo L/R input
jacks right below the ComponentVideo connector jacks.
satellite dish
cab,oTV i na,
inc,u0ing V
.......................................................
................ ®
J
RF coaxial cabl_m
HDMI cable
_udio cables
cable receiver/satellite box
You can also connect this unit to the cable receiver or satellite
box other than the HDMI or the ComponentVideo output jacks
or CompositeV deo output jack (_,=, p.26) because they mght
have diffierent output jacks.
Requ red cables and connecting methods of the cable receiver/
sateUite box, or the ava lability channel for the dear QAM may
dffer depend ng on the cable/satellite prov der or IocaF[V
broadcas_Ler:
For more nformation, please contact your cable/satellite provider
or local TV broadcaste_
No°
• Use an HDPII cabe with the HDPll logo (a re/tiffed HDbql cable),
Hgh Speed HDMI cable s recommended br the better compsJtbi i%
Plug In theAC Power Cord
Nake sure that the AC power cord must be plugged to an AC
outlet after all the necessary connections are made.
C_ut o/:
Do not connect the AC power colx) to a powor suppy outs de
the nd catr'd vo}tage ofths unit (AC 120V).
Connect ng the AC power cord to a power suppy outs de of this
range md 7 re,sut in fire or eectr ca shocks,
Note
Each time you pugn the AC power cold, no operations will be
pedormed for a f_,w seconds.This is not a malfunct on,
To Next Page
Loading...
Need help?
General
