17
English
4Use your TV
Switching on your TV and putting it in
Standby mode
To Turn the TV On from Standby or Off to Standby
• Press (3 raised dots on the Rear panel) or Front panel or the
Remote control.
Adjusting volume
To decrease or increase volume
• Press VOL ◄ / ► (1 raised dot on the Rear panel) or Front panel
or press VOL + / − on the Remote control.
VOL ◄ : Volume Down
VOL ► : Volume Up
To mute or unmute sound
• Press on the remote control to mute the sound.
• Press again or VOL + / − to recover the original sound.
Switching channels
To select Channels by using CH ▼/▲ or CH + / −
• Press CH ▼ (Down) / ▲ (Up - 1 raised dot on the Rear panel) or
Front panel or press CH + / − on the Remote control.
To select Channels by using the NUMBER buttons
• For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
– When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
– When selecting cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
* On the 46” & 50” TV’s All CONTROL Keys are located on the Rear
(lower right) side of the unit as viewed from the Front.
• Energy consumption contributes to air and water pollution. When the AC power cord
is plugged in, your TV consumes energy. Your TV has very low standby power
consumption.
LF501EM4 / LF461EM4
LF391EM4 / LE391EM4 / LF320EM4 /
LE320EM4 / LE290EM4 / LE240EM4
* Key on Rear
LF501EM4 / LF461EM4
LF391EM4 / LE391EM4 / LF320EM4 /
LE320EM4 / LE290EM4 / LE240EM4
* Keys on Rear
• To select the non-memorized channels, use the NUMBER buttons.
• No Signal will appear on the TV screen after the subchannel broadcast is over.
• Audio only program message will appear on the TV screen, when you receive only
sound signal.
LF501EM4 / LF461EM4
LF391EM4 / LE391EM4 / LF320EM4 /
LE320EM4 / LE290EM4 / LE240EM4
* Keys on Rear
Analog/Cable TV operation
To Next Page
Loading...
Need help?
General
