Eminent EM4590 - Network Cable Connection and Control Panel Access

5 | ENGLISH
connection. Also, it is advisable to fill out a fixed IP-Address for your LAN card in order
to access the EM4590.
1. Connect a network cable to the EM4590 and connect the other end to the
network card of your computer.
2. Connect the EM4590 to a wall outlet.
3. Make sure your computer is completely started.
4. Go to the ‘Control Panel’ of your computer.
5. Windows XP users need to click ‘Network connections’. Windows Vista users
need to click ‘Network and Sharing center’ and then click ‘Show network
connections’. Windows 7 users need to click ‘Network and Sharing Center’ and
then click ‘Change adapter settings’. Windows 8 users need to go to ‘Start’
(Apps) and then choose ‘All Apps’. Choose ‘Control Panel’ and click ‘Network
and Sharing Center’. Click ‘Change adapter settings’.
6. Right-click your ‘LAN’ connection and click ‘Properties’.
7. Windows XP users: Double-click ‘Internet protocol TCP/IP’. Windows Vista,
Windows 7 and Windows 8 users: Double-click ‘Internet protocol ‘TCP/IPv4’ as
shown in the following image: