Emmaljunga Toddler Roller NXT 90 - Assembly and Use of the Toddler Roller; Assembling the Brake Pedal; Mounting the Wheels

3
2
1
15
Manual Toddler Roller NXT90 v. 1.1
4
5
Assembly and use of the Toddler Roller
• Mount the wheel assembly on the board with the washer between
the wheel assembly and the nut.
• Use the ring spanner to tighten the nut until the upper end of the
nut is level with the end of the bolt.
WARNING!
• Make sure that this is done with both wheels.
• Check that the wheel and the nut are securely attached.
UK
• Place the Toddler roller pedal and the pedal bracket around the
brake pedal.
• Connect the two parts with the four ETP screws.
• Correct mounted Toddler Brake Pedal (see picture)
• To release the Brake Pedal, press hard on the Toddler Roller Pedal.