• Correctly attached seat unit and carrycot
• Maximun load 15 kg in the seat unit and 9kg in the carrycot.
WARNING
• Never attach the seat unit and carrycot in any other way than as
shown in the picture
• The most reclined position on the seat unit shall only be used for
storage.
Removing Go Double from the chassis
• Remove all seat units/carrycots/car seats and car seat adaptors from
Go Double. Pull the plastic rings on the outside of Go Double and lift
it off the chassis.
• Note, before folding the pram, all seat units, carrycots, car seats and
car seat adaptors must be removed from Go Double.
• Go Double must be removed from the chassis prior to folding.
WARNING
• Seat units, carrycots or car seats + car seat adaptors shall not be used
in any other combinations other than those shown in the pictures in this
manual (pictures 23-26).
• Note that the pram’s stability is immediately affected if you change the
weight distribution on the Go Double. Be aware that the risk of tipping
increases as soon as you attach/remove seat units, carrycots, car seats or
place children in/remove children from the pram.
• When using the Go Double never release your hands from the handle of
the pram.
• Always park on level surfaces.
• Always remove the heaviest child from the pram rst.
Attaching and using Go Double Adaptor
• Attach the carrycot to the back/top position
• Position the seat unit’s footrest in the shopping tray
To Next Page
Loading...